How do I perform a Factory Reset on my WAC Home Lighting Fixture?

There are three methods to factory reset a fixture:

1. Using the MyWAC App
   If the fixture is online, open the MyWAC app, go to the fixture settings, and select the factory reset option.
2. Using a WAC-Mesh WallStation
   If the WAC-Mesh WallStation is physically wired to the fixture, press and hold Buttons 1 and 3 for about 5 seconds, until the indicator light flashes red in the bottom-left corner. This will trigger the factory reset sequence, power cycling all fixtures wired to the WallStation.
3. Using the Pull Tab on a WAC-Mesh WallStation
   If the WAC-Mesh WallStation is physically wired to the fixture, gently pull the tab at the bottom center of the WallStation out and push it back in five times. Wait 2 seconds between each pull/push cycle to trigger the factory reset.
4. Power Cycling the Circuit Breaker
   NOTE: If you are unfamiliar with your electrical system, consult a licensed electrician before performing this procedure.
   Turn the circuit breaker that powers the fixture off and on five times. Wait 2 seconds between each off/on cycle to trigger the factory reset.

When the reset is complete, the fixture will visually confirm success by repeatedly fading its light from bright to dim and back again, creating a heartbeat-like effect.