How do I power cycle the VENTRIX CPU?

Performing a power cycle on the CPU involves using the circuit breaker. Follow these steps carefully:

1. Locate the Circuit Breaker:

   • Identify the circuit breaker associated with the CPU. This is typically located in close proximity to the CPU or within the same electrical panel.

2. Switch OFF the Circuit Breaker:

   • Toggle the circuit breaker associated with the CPU into the OFF position. Ensure a complete disconnect by verifying that the power indicator associated with the circuit breaker is off.

3. Wait for 15 Seconds:

   • Allow a 15-second pause to ensure a complete power cycle. This brief interruption helps clear any residual charge within the system.

4. Switch ON the Circuit Breaker:

   • After the 15-second interval, toggle the circuit breaker back into the ON position. Confirm that the power indicator associated with the circuit breaker is illuminated.

5. Wait for CPU Restart:

   • Allow approximately 1 minute for the CPU to power back up. During this time, the system will go through its startup process, and normal operation will resume.

Disclaimer Warning:

• Caution: Ensure you are familiar with the electrical setup and safety protocols before attempting a power cycle using the circuit breaker.

• Consult Professionals if Uncertain: If you are unsure about the location or operation of the circuit breaker, or if the power cycle does not resolve the issue, seek assistance from qualified professionals to avoid potential hazards.

• Electrical Safety: Exercise caution when working with electrical components. If you are not experienced with electrical systems, consider seeking help from a qualified technician.

• Manufacturer Guidelines: Refer to the CPU manufacturer's guidelines and documentation for any specific recommendations or precautions related to power cycling.

By following these instructions and heeding the disclaimer warnings, you can safely power cycle the CPU using the circuit breaker.